Towertalk
[Top] [All Lists]

Re: [TowerTalk] Dipole center insulator strain releif

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Dipole center insulator strain releif
From: Jim Lux <jimlux@earthlink.net>
Date: Mon, 23 Apr 2012 16:04:29 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 4/23/12 3:51 PM, Stan Labinsky Jr. wrote:
> Guys... and ladies too...
>
> All this talk of looping the coax over some sort of support and the concerns
> about bend radius and the cable weight damaging the cable at the bend,
> etc.causes me to suggest an alternative.
>
> Has anyone tried to use 1/4" or 3/16" good outdoor UV stable rope (or line
> as you wish to call it) to Whip the cable and hang it from the antenna
> insulator - a good ceramic "dog bone"?
>
> See http://en.wikipedia.org/wiki/Common_whipping
>
> The co-ax would be the rope in the image. The line end labeled "B" would be
> the end used to hang the cable (the antenna end of the co-ax being the "B"
> end of the rope).
>
> I've used this technique with good success. The cable is held by the
> multiple wraps of the whipping cord, distributing the load on the jacket
> over the many turns, the hanging lead "B" is supported at its root from the
> "A" end of the whipping, and also held in place by the same turns holding
> the cable.
>

The same basic idea as, say, Kellems grips.  the clamping/grabbing force 
is distributed over a length of the jacket.


http://www.grainger.com/Grainger/HUBBELL-WIRING-DEVICEKELLEMS-Strain-Relief-6C091?Pid=search

that one runs into a conduit fitting, but I've seen ones that terminate 
in a steel cable loop, which could attach to that center insulator.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>