Towertalk
[Top] [All Lists]

Re: [TowerTalk] Dipole center insulator strain releif

To: reflector -tower <towertalk@contesting.com>
Subject: Re: [TowerTalk] Dipole center insulator strain releif
From: Bob K6UJ <k6uj@pacbell.net>
Date: Mon, 23 Apr 2012 16:25:56 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Good idea Stan.  Then the cable is supported by the cord.
I'm getting ready to string up a dipole for 30 meters, I'll give it a try try.
I have some 3/16" black dacron polyester antenna rope that is pretty easy to 
work with.  

Bib
K6UJ



On Apr 23, 2012, at 3:51 PM, Stan Labinsky Jr. wrote:

> Guys... and ladies too...
> 
> All this talk of looping the coax over some sort of support and the concerns 
> about bend radius and the cable weight damaging the cable at the bend, 
> etc.causes me to suggest an alternative.
> 
> Has anyone tried to use 1/4" or 3/16" good outdoor UV stable rope (or line 
> as you wish to call it) to Whip the cable and hang it from the antenna 
> insulator - a good ceramic "dog bone"?
> 
> See http://en.wikipedia.org/wiki/Common_whipping
> 
> The co-ax would be the rope in the image. The line end labeled "B" would be 
> the end used to hang the cable (the antenna end of the co-ax being the "B" 
> end of the rope).
> 
> I've used this technique with good success. The cable is held by the 
> multiple wraps of the whipping cord, distributing the load on the jacket 
> over the many turns, the hanging lead "B" is supported at its root from the 
> "A" end of the whipping, and also held in place by the same turns holding 
> the cable.
> 
> All in all, a very gently way to handle co-ax.
> 
> And it's soooo simple.
> 
> Stan
> 
> ----- Original Message ----- 
> From: "K8RI" <K8RI-on-TowerTalk@tm.net>
> To: <towertalk@contesting.com>
> Sent: Saturday, April 21, 2012 10:07 PM
> Subject: Re: [TowerTalk] Dipole center insulator strain releif
> 
> 
>> On 4/21/2012 6:17 PM, Dick wrote:
>>> I just got a rope over a tree after 4 years of trying. I need a dipole 
>>> center insulator that has strain relief for the coax. To clear the 
>>> branches, the coax will be pulling against the center support rope. All 
>>> the center insulators I've seen have an SO-239, it doesn't seem like 
>>> putting that strain on a PL-259 is a good idea... Do any have a strain 
>>> relief??
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>