Re: [TowerTalk] Rohn 25G

["Larry" <lknain@nc.rr.com>]

In general at 100 feet Rohn suggests 3 guys 33, 66, and 99 feet. Somewhere 
around 75 feet and below it is generally 2 guys as I recall. But it does 
depend on the load. How much do you have above the top of tower and a myriad 
of other factors need to be considered.
73, Larry  W6NWS

-----Original Message----- 
From: Mark Robinson
Sent: Sunday, August 18, 2013 5:14 PM
To: Larry ; towertalk@contesting.com
Subject: Re: [TowerTalk] Rohn 25G

I guess it depends on what windload you want the tower to withstand.

If it was my tower I would use more than 2 guy wires. Best to consult the
Rohn 25 drawings.

According to Rohn my tower can take 120mph, the mast 105mph and the beams
100 mph. I hope I never need to put that to the test.

73 Mark N1UK


----- Original Message ----- 
From: "Larry" <lknain@nc.rr.com>
To: <towertalk@contesting.com>
Sent: Sunday, 18 August, 2013 4:59 PM
Subject: Re: [TowerTalk] Rohn 25G


> Depends on height and load. It is not a rigid "every 20 feet" or even 
> "every n feet".
> 73, Larry  W6NWS
>
> -----Original Message----- 
> From: Mark Robinson
> Sent: Sunday, August 18, 2013 4:48 PM
> To: K7LXC@aol.com ; towertalk@contesting.com ; turvin2009@yahoo.com
> Subject: Re: [TowerTalk] Rohn 25G
>
> I thought Rohn 25 should be guyed every 20 feet. If you are not using a 
> wall
> bracket then I would install 3 sets of guys.
>
> Mark N1UK
>
> ----- Original Message ----- 
> From: <K7LXC@aol.com>
> To: <towertalk@contesting.com>; <turvin2009@yahoo.com>
> Sent: Sunday, 18 August, 2013 1:58 PM
> Subject: Re: [TowerTalk] Rohn 25G
>
>
> > >  I am a newbie. I am putting up a 60' Rohn 25G with 2 sets  of guys.
> > >  My question concerns the baseplate. The baseplate only  uses a pier pin
> > to hold it in place. It seems to me that this would allow the  base plate 
> > to
> > move.
> >
> >    Where would it move to?
> >
> >    Pier pins are typically used with bigger, heavier  towers because it
> > more or less equalizes the leg stresses. In your case I'd  suggest just
> > burying some of the bottom section in concrete. It's much easier to erect 
> > with
> > the bottom section locked in. With a pier pin, you'll have to use 
> > temporary
> > guying to get it erected.
> >
> >    If your base is already poured, I'd recommend  bolting the baseplate 
> > to
> > the base. (Use a rotary hammer and epoxy to set the  bolts.)
> >
> >     For a newbie, I don't recommend messing with  temporary guys. You 
> > need
> > solid rigging skills and the right equipment to do that  safely. And 
> > people
> > still get hurt by using them. Set it in concrete.
> >
> >
> > >  The 1st set of guys wires go at 28'
> > What is the safest method  for installing the 10' sections prior to 
> > having
> > the 1st set of guys in place? I  am not using a crane. I am using a gin
> > pole. I want to make sure that it does  not fall over while I am the 
> > process of
> > getting to the height of where the 1st  guys go.
> >
> >    See comments above. If you're going to proceed with  temporary guys,
> > use some of your precut guys for temps since ropes are stretchy.  A 
> > comealong,
> > guy grip, nylon slings and some carabiners or shackles will be very
> > useful. ALL of this is covered in my UP THE TOWER book which I strongly 
> > suggest
> > you read. (Available from _www.championradio.com_
> > (http://www.championradio.com) )
> >
> > Cheers,
> > Steve      K7LXC
> > TOWER TECH
> > and
> > Champion Radio Products
> > Cell: 206-890-4188
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk