IMO. Tom I see no problem . The only caveat is to use the, total hight and
using the highest pic point
Wayne W3EA
Ps. Leon would have "just went for it"
Sent from my iPad
On May 25, 2014, at 1:44 PM, "Tom Hybiske" <hybiske1@verizon.net> wrote:
> I was wondering if anyone had any opinion on lifting the final section of
> 25G, top stub and thrust bearing installed, along with a 30 pound mast nested
> within the section. My gin pole utilizes a 12’ length of 6061-T6 aluminum,
> 2” diameter, 3/8 wall thickness. The combines weight of the the assembly is
> close to 80 lbs. The gin pole has been very sturdy during individual section
> lifts, but I don’t know if #80 is pushing it.
>
> Tom Hybiske, K3GM
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|