Hi Tony,
I would use a nibbler if it's small enough. Start by drilling a small
hole to fit the nibbler and
expand the hole to fit the F-connector. You can get a nibbler on Amazon
for $ 14.00.
Alternatively, drill a hole to fit the F-connector and before tightening
the nut
put a few drops of epoxy or Gorilla glue between the connector and the hole.
The old fashioned way - drill a hole and expand it with a file.
If the nibbler is to big use second or third alt.
Bert VE3NR
PS. Maybe you can find a Greenlee punch if you have to make many holes.
On 3/11/2019 6:34 PM, tony.kaz--- via TowerTalk wrote:
Does anyone know of a tool that makes a nice hole in Carlon boxes for a
female F-connector with two flats that makes a nice hole so the connector
doesn't spin?
Tnx
N2TK, Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|