To: | jimlux <jimlux@earthlink.net>, towertalk@contesting.com |
---|---|
Subject: | Re: [TowerTalk] Tool for F-connector holes |
From: | "Richard (Rick) Karlquist" <richard@karlquist.com> |
Date: | Tue, 12 Mar 2019 08:31:17 -0700 |
List-post: | <mailto:towertalk@contesting.com> |
On 3/12/2019 7:23 AM, jimlux wrote: what about making a sheet metal "cookie cutter" that you could heat up and stamp through?_______________________________________________ Or, look up "broaches". I've seen those used in machine shop to make odd ball holes. Probably way too expensive for hams. Rick N6RK _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] Tool for F-connector holes, jimlux |
---|---|
Next by Date: | Re: [TowerTalk] Thrust bearing discussion, Doug Renwick |
Previous by Thread: | Re: [TowerTalk] Tool for F-connector holes, jimlux |
Next by Thread: | Re: [TowerTalk] Tool for F-connector holes, Grant Saviers |
Indexes: | [Date] [Thread] [Top] [All Lists] |