On 3/12/19 4:38 AM, tony.kaz--- via TowerTalk wrote:
Thanks for all the feedback.
I am using Amphenol F Bulkhead Crimp Jacks for RG-179. Part #222114-10.
Greenlee doesn't make a DD punch that small.
I have to drill 14 holes total on several Carlon boxes. And the connectors
are already crimped on the RG-179.
It looks like I have two choices. Make a template for the size and shape.
Drill a small hole. Then use my Rotozip Spiral saw to get the correct size
and shape.
Or drill a .375+" hole, use a few drops of epoxy then put on the washer and
nut and tighten.
I am leaning towards using the Rotozip as then for sure the connector won't
turn and easy to replace if needed.
I had thought there would be something that was off the shelf and not
exorbitant in price to make these type holes.
what about making a sheet metal "cookie cutter" that you could heat up
and stamp through?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|