VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] rover tech - coax

To: jcplatt1@mmm.com, vhfcontesting@contesting.com
Subject: Re: [VHFcontesting] rover tech - coax
From: Paul Kiesel <k7cw@yahoo.com>
Date: Wed, 11 Jul 2007 10:10:02 -0700 (PDT)
List-post: <mailto:vhfcontesting@contesting.com>
I think RG-213 has its place for rover installations.
In the cases where fatigue breaks the coax, one must
look at compromises. RG-213 is a compromise. But, if
you were finding it necessary to repair coax on every
trip, wouldn't it be prudent to consider such a
compromise?

K7CW

--- jcplatt1@mmm.com wrote:

> For my rover I use LMR-400 for 2m through 3456.  
> Each run is about 12' or
> so.   This is one of the advantages that a rover
> has, short feedlines.
> LMR-400 is wonderful stuff - excellent performance,
> moderately flexible
> with big loops where needed, rugged, the
> N-connectors are a breeze to
> install, and not too expensive.    I would not
> recommend the ultra-flex
> .... not needed for a rover.    Going to anything
> larger has little, or no,
> performance advantage, but is more difficult and
> costly to install.
> LMR-400 ... good stuff.   Been using it for multiple
> years (for roving) and
> have not had a failure with it.   I would not
> hesitate to use RG-213 for 6m
> through perhaps 432 given the short runs either.
> 
> 73, Jon
> W0ZQ/R
> 
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
>
http://lists.contesting.com/mailman/listinfo/vhfcontesting
> 



       
____________________________________________________________________________________
Sick sense of humor? Visit Yahoo! TV's 
Comedy with an Edge to see what's on, when. 
http://tv.yahoo.com/collections/222
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

<Prev in Thread] Current Thread [Next in Thread>