VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] KU4AB 6m Loop vs. PAR Moxon

To: "vhfcontesting@contesting.com" <vhfcontesting@contesting.com>
Subject: Re: [VHFcontesting] KU4AB 6m Loop vs. PAR Moxon
From: beamar via VHFcontesting <vhfcontesting@contesting.com>
Reply-to: beamar <beamar@aol.com>
Date: Thu, 30 Oct 2014 08:19:00 -0400
List-post: <vhfcontesting@contesting.com">mailto:vhfcontesting@contesting.com>
I was not familiar with KU4AB. So, I  went to the KU4AB website. He has some 
interesting antennas, at good prices. The tri band antenna looks very 
interesting. But, if he doesn't perform, it isn't very cheap or very good. 
Maybe somebody will forward these posts to him.

Buddy WB4OMG

On Oct 29, 2014, at 9:04:19 PM, "Andrew Glasbrenner" 
<glasbrenner@mindspring.com> wrote:

From:   "Andrew Glasbrenner" <glasbrenner@mindspring.com>
Subject:        Re: [VHFcontesting] KU4AB 6m Loop vs. PAR Moxon
Date:   October 29, 2014 9:04:19 PM EDT
To:     "Jarred Jackson" <jarred.jackson@hotmail.com>
Cc:     "vhfcontesting@contesting.com" <vhfcontesting@contesting.com>
AJ4LU and I used one for several run and gun rover ops, covering 20+ grids at 
70 MPH. We even turned it in motion with no issues other than mounting it 
backwards the first time!

73, Drew KO4MA

Sent from my iPad

> On Oct 29, 2014, at 8:59 PM, Jarred Jackson <jarred.jackson@hotmail.com> 
> wrote:
> 
> I have a 3 element yagi for 6m, but it seems a bit too much for me to take 
> out on the rover for contests. So in May I ordered a 6m loop from KU4AB using 
> the website. After months of waiting, a phone call, and several emails, I 
> gave up and consider my $87 lost. But this provided the opportunity to look 
> into other antennas and came across the PAR Moxon. The company was very 
> responsive and the antenna performs nearly as well as my yagi. Its a bit 
> bigger than the loop might have been, but it fits just fine on the rover mast 
> and has some gain. I have not yet experienced 60mph highway speeds. If anyone 
> has any experience with the PAR 6m Moxon in a rover application I would like 
> to know if it holds up or if I should take the wire and side "sticks" off 
> while traveling. 
> 
> Jarred - KF2MR
> 
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting


_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

<Prev in Thread] Current Thread [Next in Thread>