It went without any hitches for me a week ago also. Userport was easily
installed and configured per the instructions. Note that a specific
configuration for the exact port address on the PC is required. The default
addresses shown as it starts up were NOT correct for my port.
Good luck.
Jerry W4UK
At 15:23 2/3/2005, jduerbusch@charter.net wrote:
After reading there comments on the cw keying I decided to try it last
night. I had recently upgraded to Win/XP from Win98SE and I had been
keying cw with WL on a comport.
Looking at the Port setup on WL all the LPT ports where grayed out. After
I ran the program Userport and re-booted I now have LPT1 and LPT3 open and
both work fine CW keying my rig.
One note, the Writelog.ini file address for LPT1 ~ 3 need to be the same
as what Windows has listed.
So bottomline is that it works fine.
But my other problem is that in DXBase2005 I can't get it to send CW from
the LPT port, go figure??
Joe K0BX
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|