WriteLog
[Top] [All Lists]

Re: [WriteLog] CW keying on LPT1 with XP

To: jeflanders@comcast.net
Subject: Re: [WriteLog] CW keying on LPT1 with XP
From: k2qmf@juno.com
Date: Thu, 3 Feb 2005 17:57:15 -0500
List-post: <mailto:writelog@contesting.com>
Well how in the world do I get the correct
port address??  And what do I do with it when
I get it????????????????
  
H E L P...........    K2QMF


On Thu, 03 Feb 2005 16:26:22 +0000 Jerry Flanders
<jeflanders@comcast.net> writes:
> It went without any hitches for me a week ago also. Userport was 
> easily 
> installed and configured per the instructions. Note that a specific 
> 
> configuration for the exact port address on the PC is required. The 
> default 
> addresses shown as it starts up were NOT correct for my port.
> 
> Good luck.
> 
> Jerry W4UK
> 
> At 15:23 2/3/2005, jduerbusch@charter.net wrote:
> >After reading there comments on the cw keying I decided to try it 
> last 
> >night.  I had recently upgraded to Win/XP from Win98SE and I had 
> been 
> >keying cw with WL on a comport.
> >
> >Looking at the Port setup on WL all the LPT ports where grayed out. 
>  After 
> >I ran the program Userport and re-booted I now have LPT1 and LPT3 
> open and 
> >both work fine CW keying my rig.
> >
> >One note, the Writelog.ini file address for LPT1 ~ 3 need to be the 
> same 
> >as what Windows has listed.
> >
> >So bottomline is that it works fine.
> >
> >But my other problem is that in DXBase2005 I can't get it to send 
> CW from 
> >the LPT port, go figure??
> >
> >Joe K0BX
> 
> 
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
> 
> 
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>