I am having trouble getting my new SIIG PCI 4 Serial Port board to key FSK.
I have a PC with one built in Serial Port. The built in serial port (at
COM 1) keys FSK no problem.
When I install the SIIG board, it adds COM 5, 6, 7, and 8.
I use COM 5 and 6 for Rig control with no problem. However, if I select
COM 7 or 8 to key FSK in MMTTY, my PC crashes and immediately re-boots. I
temporarily took the radio off of COM 5 and 6 and tried those for FSK - same
result. No matter what port I chose on the SIIG board, selecting it to key
FSK crashed my computer. It crashes as soon as I make the selection in RTTY
Operating System is XP.
Has anyone run into this issue? Any suggestions on what I might try?
73,
Al, K0AD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|