Mike, K2MK, wrote:
> I was wondering if anyone was successfully sending K3
> commands using 10.80.
> I am only able to get the following error message along the
> status line:
> error result -3 sending rig command(10)
>
> I believe I have followed the instructions properly. I
> entered the following information in the Keyboard Shortcuts
> and then saved the configuration:
> SUBTRACT=Rig1Command(10)
> I'm using the subtract key but I also tried this using F12.
> My K3 is on COM port 1.
>
> I've modified the ini file located in the Virtual Store
> directory of my Vista PC to include the following line.
> Macro_10=SWT42;
> This is the command for CW AUTO SPOT.
>
> The header line of [Elecraft_K3_commands] was not in my ini
> file so I entered it also. I put both lines just above the
> [Summary] header as
> follows:
> [Elecraft_K3_commands]
> Macro_10=SWT42;
>
> Any help would be appreciated.
I don't know about Vista and Virtual Store directory, but the K3 command
feature works fine here with XP, SP3. I also don't know what error result
-3 means but I can get error result -1 if the K3 is not properly interfaced
and talking to WriteLog. I assume the K3 is otherwise interfaced and
working properly with WriteLog? It looks like you have the right ini file
entries and keyboard shortcut setups.
Ed - W0YK
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|