WriteLog
[Top] [All Lists]

Re: [WriteLog] Sending K3 commands in 10.80

To: "'ww2r2'" <ww2r2@g4fre.com>, "'WriteLog Reflector'" <WriteLog@CONTESTING.COM>
Subject: Re: [WriteLog] Sending K3 commands in 10.80
From: "KD3TB" <idarack@gmail.com>
Date: Fri, 8 Oct 2010 11:32:55 -0400
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
I am attempting the same thing with no luck.

I have entered in my Writelog.ini file the following commands:

[Elecraft_K3_commands]
Macro_10=SWT21;

Where SWT21; should play message number 1 from the K3 DVK. I get an error
that it cannot find the associated wave file?

I have tested with another program and know this is the correct K3 command.

Any help would be appreciated.

Thanks, Irwin KD3TB



-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of ww2r2
Sent: Tuesday, October 05, 2010 7:12 PM
To: WriteLog Reflector
Subject: Re: [WriteLog] Sending K3 commands in 10.80

yes, under xp

[Elecraft_K3_commands]
Macro_11=SWT11;

along with

f12>rig2command(11)

had f12 swapping vfos happily

Dave

ww2r

-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of K2MK
Sent: Tuesday, October 05, 2010 8:26 AM
To: WriteLog Reflector
Subject: [WriteLog] Sending K3 commands in 10.80


I was wondering if anyone was successfully sending K3 commands using 10.80.
I am only able to get the following error message along the status line:
error result -3 sending rig command(10)

I believe I have followed the instructions properly. I entered the following
information in the Keyboard Shortcuts and then saved the configuration:
SUBTRACT=Rig1Command(10)
I'm using the subtract key but I also tried this using F12. My K3 is on COM
port 1.

I've modified the ini file located in the Virtual Store directory of my
Vista PC to include the following line.
Macro_10=SWT42;
This is the command for CW AUTO SPOT.

The header line of [Elecraft_K3_commands] was not in my ini file so I
entered it also. I put both lines just above the [Summary] header as
follows:
[Elecraft_K3_commands]
Macro_10=SWT42;

Any help would be appreciated.

73,
Mike K2MK

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.856 / Virus Database: 271.1.1/3175 - Release Date: 10/03/10
13:33:00

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>