Hi John. Find a piece of wood, maybe a 2x4 and saw a slot in one end width-wise
deep enough to firmly hold a partially inserted staple without it bending. Push
or drive with a hammer against the 2x4 and force the staple into the ground
over the wire flush with the end of the wood. Remove the wood (might need to
tip sideways to release the staple if it’s tight in the slot), turn the wood 90
deg, and push down again to finish implanting the staple. Might work, never
done it.
73, Gary NL7Y
> is there a simple , not overly expense tool to set land scape staples while
> standing?? at 73, I do not want to go through being on my hands and knees
> driving the staples in with a hammer.
> thanks john w8wej
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|