Hello to the group....I am looking for a source for a positioning
Potentiometer, with the parameters of: 500 Ohms, Wire wound, Single turn
(very important) precision potentiometer. This pot will hopefully have a
shaft approx. 1/4 inch in diameter. I want to change out my Selsyns on my
prop pitch motor and controller and be able to use a CDE or HyGain control
box for the dial indicator. A friend of mine in Europe has made this
conversion and it seems to work fine for him.
Your input is appreciated...Have a good weekend from Sunny, Warm, Southern
California.
73's......Lonnie (NT6B)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
--
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: [email protected]
Administrative requests: [email protected]
Problems: [email protected]
|