I have a few problems with this wire. My experience with aluminum is
that it is not worth the trouble integrating it into the rest of the
antenna system when it comes to bonding it to other metals. I
appreciate the light weight and lower cost but aluminum has another
undesirable property: It cold flows so clamps on it eventually come
loose and then you have resistance and heat. This is why aluminum
house wire which was tried in the 1960s came to a quick end--too many
cold flows, heat and fires. I hope it isn't coming back for that
purpose.
I have my 200 amp service drop to my home using aluminum. I don't
like it but I can't make the power company use copper. Every few
years I check the lugs on the main breaker to make sure they are still
tight. This is one area where an IR camera would come in handy. It
WILL cold flow eventually and you'll know it when your lights flicker
or dim briefly when a big load like A/C comes on.
I was dismayed to see that QST ran an article by some sort of RF
expert on how to construct open wire feedline using aluminum AWG 8 or
maybe it was 6, stranded wire. Ridiculous overkill for ham power, and
he spliced line sections together using what appeared to be steel
clamps. Those clamps will lose their grip in a few years and he'll
have problems, besides the use of steel for RF. None of this came up
in the article. Then there was the line Z due to the spacing and
diameter of AWG 8 cable but that's outside the focus here.
73
Rob
K5UJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|