Good reminder to always use hot dipped galvanized hardware.
I have successfully used GM Heat Valve Lubricant for many years. I can
still be purchased at the local Chevrolet dealer.
73, Keith NM5G
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Riki, K7NJ
Sent: Saturday, April 4, 2020 3:38 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Opening Steel Hardwre AFter 15 Years
Fifteen years ago, I had attached a tower to threaded steel studs
protruding from the tower's concrete base. Now, I need to replace the tower.
Even though I used highly recommended "PB Blaster", it was almost impossible
to loosen the nuts from the studs. Finally, I was able to open them, but not
without thoughts of a nightmare scenario where the studs might have been
broken, etc.. I would like to be sure that this situation will never happen
again. I'm convinced that I should have applied something to protect the
hardware when the tower was first installed. I have several ideas, but this
is something I don't care to experiment with for obvious reasons. I'm
looking for something that has actually been done and worked. Any actual
time proven (!) suggestions would be appreciated.
73, Riki K7NJ
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|