Amps
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [Amps] SB-220 bias question

from [DF3KV] [Permanent Link][Original]
To: <amps@contesting.com>
Subject: Re: [Amps] SB-220 bias question
From: "DF3KV" <df3kv@t-online.de>
Date: Sat, 29 Aug 2009 18:56:58 +0200
List-post: <amps@contesting.com">mailto:amps@contesting.com> 
To do so you have to modify the pi-net, as the output impedance of the tube
will be much higher

73
Peter

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On 

My whole point is to run the tubes at higher plate voltage with less plarte
and grid current for the same power output

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [Amps] SB-220 bias question, gudguyham
Next by Date:  Re: [Amps] SB-220 bias question, gudguyham
Previous by Thread:  Re: [Amps] SB-220 bias question, gudguyham
Next by Thread:  Re: [Amps] SB-220 bias question, gudguyham
Indexes:  [Date] [Thread] [Top] [All Lists]