OCFD fed with open wire? I suppose everyone else here understands how that
would work but I don't. Wouldn't the imbalance of the antenna turn the open
wire into a radiator or did you have some kind of choke up in the air?
Jon
On Sep 14, 2014, at 11:42 AM, Rick - DJ0IP / NJ0IP wrote:
> Don, you put me on the spot here.
> I have never tried a 44' OCFD.
> I have tried both the 66' and 132' OCFD fed at that split, fed with open
> wire, but not the 44'.
> I don't like to comment on things that I have not actually tried myself.
>
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Don Jones
> Sent: Sunday, September 14, 2014 5:47 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Zepp?
>
> I like the 44ft doublet idea.
> But I would like to try the OCF method mentioned by Rick DJ0IP.
> Sounds like for a 44 ft OCF antenna the feed point would be 19ft/25ft.
> Correct?
> Hoping I can get 10M to play better and would like better efficiency as
> compared to a 34 doublet on 30M.
> 73, Don
>
>
> On 9/13/2014 7:29 PM, Augie "Gus" Hansen wrote:
>>
>> <snip>
>> Elecraft sells a nice low-power balun that is switchable as 1:1 or
>> 4:1. I have used it for field/portable ops, but it's usually set to
>> 1:1 for the antennas I use (44' or 88' doublet).
>>
>> 73,
>> Gus
>> <snip>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|