TenTec
[Top] [All Lists]

Re: [TenTec] repairs

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] repairs
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 27 Oct 2014 09:10:56 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Just a note that sometime in the first half of 1998, about a year into
production, Ten-Tec changed the Omni 6+ logic board, PBT board, Control
board and IF/AF board to use SMD components.  The 9Mhz Xtal Filter board
used SMD from the start

73, Barry N1EU

On Mon, Oct 27, 2014 at 4:18 AM, Wade Staggs <tvman1954@gmail.com> wrote:

> *The 585 Paragon is New enough to be Dead Bang on Frequency and is very
> easy to repair. Same thing with the Omni 6 Rigs. Although the Older
> production runs are best, where surface mount components are concerned. You
> could always purchase an old Omni D and add one of the DDS kits to it.
> After adding the DDS Kit, they are very stable rigs.*
>
> *                                                                73 from
> Wade/KJ4WS*
>
> On Sun, Oct 26, 2014 at 6:17 PM, Spencer <k5gak@powerc.net> wrote:
>
> > Are there any radios that are user serviceable other than the antiques?
> If
> > I am in the middle of nowhere and my radio quits
> > then what?
> >
> > Spencer W1GAK
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>