Re: [TenTec] having problem getting amp to work with Orion II

["John Molenda" <cdistflatfoot@gmail.com>]

Roger , I double checked that and thanks .  John
----- Original Message ----- 
From: "John" <fraz1@bellsouth.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 7:18 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II


> John....just checking the obvious.  On the back of the O II, the TX en and
> out are in the vertical plane.  IE, one above the other.  Make sure you 
> have
> the both cables under the same keying loop (either 1 or 2).
>
> 73 W4II
> ----- Original Message ----- 
> From: "John Molenda" <brazos@rochester.rr.com>
> To: <ac5aa@ac5aa.com>; "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Sent: Monday, March 22, 2010 6:02 PM
> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>
>
> > roger coax connected
> > ----- Original Message ----- 
> > From: "Duane Calvin" <ac5aa1@gmail.com>
> > To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> > Sent: Monday, March 22, 2010 6:51 PM
> > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> >
> >
> > > Oops - three cables - don't forget the exciter RF!  :-)
> > >
> > > Duane Calvin, AC5AA
> > > Austin, Texas
> > > www.ac5aa.com
> > >
> > >
> > > -----Original Message-----
> > > From: tentec-bounces@contesting.com
> > > [mailto:tentec-bounces@contesting.com]
> > > On Behalf Of John
> > > Sent: Monday, March 22, 2010 5:35 PM
> > > To: Discussion of Ten-Tec Equipment
> > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > >
> > > That is correct John!
> > >
> > > 73 John W4II
> > > ----- Original Message ----- 
> > > From: "John Molenda" <brazos@rochester.rr.com>
> > > To: "aa4nn" <aa4nn@earthlink.net>; "Discussion of Ten-Tec Equipment"
> > > <tentec@contesting.com>
> > > Sent: Monday, March 22, 2010 5:19 PM
> > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > >
> > >
> > > > I have reread the manual and looked at the hookup my question is this
> > > > (when
> > > > hooking Orion II to titan III amp ) there are only two cables to run
> > > > between
> > > > the two tx en out  key in out .  and then use the switch on the amp in
> > > > qsk
> > > > mode .  then go to the tx menu and enable loop 1 .  is this correct am 
> > > > I
> > > > missing a hookup ?  thanks John kb2huk
> > > > ----- Original Message ----- 
> > > > From: "aa4nn" <aa4nn@earthlink.net>
> > > > To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> > > > Sent: Monday, March 22, 2010 9:14 AM
> > > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > > >
> > > >
> > > > > Does the term QSK or PTT ring a bell?
> > > > > de Joe, aa4nn
> > > > > Lake Wylie, SC
> > > > > ------------------------------------------------------
> > > > > > > Hello all , I am having a problem getting my Orion II to work with 
> > > > > > > my
> > > > > > > Titan III
> > > > > _______________________________________________
> > > > > TenTec mailing list
> > > > > TenTec@contesting.com
> > > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > >
> > > ----------------------------------------------------------------------------
> > > ----
> > >
> > >
> > >
> > > No virus found in this incoming message.
> > > Checked by AVG - www.avg.com
> > > Version: 8.5.437 / Virus Database: 271.1.1/2763 - Release Date: 03/22/10
> > > 07:33:00
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> --------------------------------------------------------------------------------
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.437 / Virus Database: 271.1.1/2763 - Release Date: 03/22/10
> 07:33:00
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec