Not here. I can cycle the radio on and off and the set DSP BW in all four
(A thru D) band registers and all are recalled, every time, with complete
accuracy to what I set last.
73, Bob K8IA, President
Arizona Outlaws Contest Club
Club Call; N7AT
Website: _www.arizonaoutlaws.net_ (http://www.arizonaoutlaws.net/)
In a message dated 6/17/2010 6:36:53 P.M. US Mountain Standard Time,
w3krq@dejazzd.com writes:
they are talking the dsp bw not the trsnsmitt bw i set my dsp bw to 2800
turn off and back on the dsp bw goes to 3000
----- Original Message -----
From: "Troy W6HV" <w6hv@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, June 17, 2010 9:29 PM
Subject: Re: [TenTec] bugs in Orion firmware 2.044A
> Ditto with mine. Goes to what I had set previously.
> Troy, W6HV
>
> --------------------------------------------------
> From: "Phil Howlett" <w9xx@hoosierbroadband.com>
> Sent: Thursday, June 17, 2010 5:25 PM
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Subject: Re: [TenTec] bugs in Orion firmware 2.044A
>
>> Same here....No problem. Plays very well. Bad download?
>> W9XX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
(http://www.arizonaoutlaws.net/)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|