It's in the PDF file that was posted by someone earlier. There was nothing in
it though about class AB RF amp operation.
http://www.mif.pg.gda.pl/homepages/frank/sheets/088/3/3-500Z.pdf
Best,
Will
*********** REPLY SEPARATOR ***********
On 6/27/06 at 1:31 PM R L Measures wrote:
>On Jun 27, 2006, at 6:51 AM, Will Matney wrote:
>
>> Rich,
>>
>> It was the same thing as they printed it I was refering, or to me
>> it was as I wrote it. It was Eimacs maximum rating at 1 KW input, G-
>> G, class B RF amp showing it's minimum distortion, or the way they
>> have it listed.
>
>I have seen no info from Eimac on Class B for the 3-500Z.
>>
>> Best,
>>
>> Will
>>
>> *********** REPLY SEPARATOR ***********
>>
>> On 6/27/06 at 6:19 AM R L Measures wrote:
>>
>>> On Jun 27, 2006, at 2:46 AM, Tom W8JI wrote:
>>>
>>>>> They can be used on up in current, say for pulse circuits
>>>>> and RF heating. The 400 mA is the maximum plate current at
>>>>> single tone for minimum distortion. That's for 600 watts
>>>>> PEP useful power each. That's listed in the tables on page
>>>>> 2 or 3 under a class B RF amp.
>>>>
>>>> Will,
>>>>
>>>> Where did you get the idea 400mA is a "minimum distortion"
>>>> condition?
>>>
>>> Good point, Tom. Will should have said something like: for minimal
>>> distortion, the max rated anode-I is 400mA.
>>>>
>>>> 73 Tom
>>>>
>>>>
>>>>
>>>>
>>>>
>>>> _______________________________________________
>>>> Amps mailing list
>>>> Amps@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/amps
>>>>
>>>
>>> R L MEASURES, AG6K. 805-386-3734
>>> r@somis.org
>>
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
>R L MEASURES, AG6K. 805-386-3734
>r@somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|