On Jun 27, 2006, at 6:51 AM, Will Matney wrote:
> Rich,
>
> It was the same thing as they printed it I was refering, or to me
> it was as I wrote it. It was Eimacs maximum rating at 1 KW input, G-
> G, class B RF amp showing it's minimum distortion, or the way they
> have it listed.
I have seen no info from Eimac on Class B for the 3-500Z.
>
> Best,
>
> Will
>
> *********** REPLY SEPARATOR ***********
>
> On 6/27/06 at 6:19 AM R L Measures wrote:
>
>> On Jun 27, 2006, at 2:46 AM, Tom W8JI wrote:
>>
>>>> They can be used on up in current, say for pulse circuits
>>>> and RF heating. The 400 mA is the maximum plate current at
>>>> single tone for minimum distortion. That's for 600 watts
>>>> PEP useful power each. That's listed in the tables on page
>>>> 2 or 3 under a class B RF amp.
>>>
>>> Will,
>>>
>>> Where did you get the idea 400mA is a "minimum distortion"
>>> condition?
>>
>> Good point, Tom. Will should have said something like: for minimal
>> distortion, the max rated anode-I is 400mA.
>>>
>>> 73 Tom
>>>
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>>
>>
>> R L MEASURES, AG6K. 805-386-3734
>> r@somis.org
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
R L MEASURES, AG6K. 805-386-3734
r@somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|