About the same way any antenna relay is handled; they work fine for years
and then either replace or clean. With gold flash I guess it depends upon
what is under it and how it takes to burnishing. It also happens to vacuum
relays where reversing the 24V wires and/or temporarily running exciter
power (aka barefoot) thru the receive side often restores them for long
periods (years).
Carl
KM1H
> That begs a question I've often puzzled over: how does a contact rated at
> 10A cope with uV level signals, particularly after the gold flash has gone
> ?
>
> David
> G3UNA
>
>
>>I did a survey about 15 years ago on CQ-Contest (then the only reflector
>> available). IIRC, there were essentially no complaints about the
>> Ameritron RCS-8 or the TopTen remote relay box. I used two TopTens for
>> maybe 10 years, often operating into >3:1 SWRs at >1200 watts (for
>> example, running an 80m array cut for CW up in the DX phone window) and
>> never had any relay problems. Currently using an RCS-10, which can have
>> up to 7 relays in the RF path. Will be interesting to see how it holds
>> up.
>>
>> Right now my Array Solutions Stackmatch has a bad relay (dirty?).
>> Symptom is occasional high SWR and a lack of received signal on the
>> lower antenna in my tribander stack. If I send a little high power RF
>> through it things are then fine.
>>
>> 73, Pete N4ZR
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|