Has senao certified this card with any antenna's?
Dan Metcalf
Wireless Broadband Systems
dan.metcalf@wbsysnet.com
781-658-2075
www.wirelessbroadbandsystems.com
-----Original Message-----
From: Norm Young [mailto:npyoung@applegatebroadband.net]
Sent: Friday, May 17, 2002 12:00 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] higher power cards, what works, what doesn't
Dan, I'm using a PRISM II card I got from Tony (it's a Senao,
http://www.senao-usa.com/SL-2011CDEXT.htm). Had some initial problems with
it in my PtMP (I think I may have some problems with connectors or with the
antenna itself) side, but switched over to the PtP side (I have an 18 mile
backhaul) and it seems to be working quite well. (I'm surprised that
reflected RF, if that is what it was, would cause the card to fruit-out like
it did. Rx sensitivity went to hell, and there were problems doing remote
reboots on the AP.)
Norm
----- Original Message -----
From: "Dan Metcalf" <danm@suncorstainless.com>
To: <karlnet@WISPNotes.com>
Sent: Friday, May 17, 2002 8:08 AM
Subject: [Karlnet] higher power cards, what works, what doesn't
> How many people out there are using the 100mw & 200mw cards w/ Karlnet
> v4.02? what works what doesn't? I couldn't get the symbol24 card to work.
> Also when you setup the rg1000 do you tell it what type of card is in the
> interface or do you leave it at default?
>
> Dan Metcalf
> Wireless Broadband Systems
> dan.metcalf@wbsysnet.com
> 781-658-2075
> www.wirelessbroadbandsystems.com
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|