Dukor,
I am suprised you cannot change the frequency remotely. Latency should not
be the issue, it sounds much more like an RF issue. Regardless of the
software, you still have to have good RF for wireless to work well.
Kevin
____________________________________
Kevin R. Knuth
Business Development Manager
North America
Corporate Office: 614-822-5275 x130
Home Office: 260-424-9690
Cell Phone: 260-402-6086
Email: kknuth@karlnet.com
www.karlnet.com
____________________________________
This message is intended only for the use of the Addressee and may contain
information that is CONFIDENTIAL. If you are not the intended recipient,
you are hereby notified that any dissemination of this communication is
strictly prohibited. If you have received this communication in error,
please notify us immediately and erase all copies of the message and its
attachments. Thank you.
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Darko Budor
Sent: Thursday, December 19, 2002 12:45 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] RG-1100 END OF LIFE!
On Thu, Dec 19, 2002 at 08:12:17AM -0500, Russ Kreigh wrote:
> I myself, coming from a Cisco world think that Karlnet is some of the
> easiest stuff to configure out there. I would say the hardest part is
> generating keys and uploading, but the actual configuration is a breeze. I
> mean, if you understand Cisco NAT and the lines of config to do that,
> marking a checkbox and typing two IPs can't really be that hard, can it?
The
> one thing that is much easier to do on Cisco's for me is routing, but
that/s
> just me. Anyway, enough rambling I have to get to work :-P
Coming from the Cisco world, how do you feel about explaining a dozen of
pissed off customers why did everything stop for a half a minute while you
were changing config?
How do you feel if you have to drive to the CPE site to change the channel
on that CPE, because some MORON was interfering with the channel you were
using and you just can't upload the config on remote CPE cause the latency
was too high...
--
Darko Budor <budor (at) vodatel (dot) hr>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|