it increases the max Rx sensitivity or your clients (e.g., 1 Mb @ -94 vs 11
Mb @ -82), but causes you to waste more of your over-the-air time
e.g., if you were at 11 Mb vs 1 Mb, your 1 Mb clients (net net) would
transmit approximately 10x faster (e.g., more net capacity per
basestation...bandwidth disclaimers apply)
-Charles
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Ben Polson
Sent: Monday, March 10, 2003 3:34 PM
To: Karlnet Mailing List
Cc: support@karlnet.com
Subject: RE: Satellites problems (was RE: [Karlnet] Three different
AP1000keep loosing one card)
Does anyone know what the effects are of setting all the satellite stations
to 1Mbit or 2Mbit and setting the base station to 11Mbit? My service plans
only go up to 768k right now, so if it would help me to change them all to 1
or 2 Mbit then I'd like to know... Thanks in advance!
-Ben.
> Hello,
>
> I have been chasing this problem since 3.75 if my memory serves me
> correctly. The only workaround we have found is to set the base to
> 5.5Mbit in the sensitivity setting (Medium), and if a satellite STILL
> causes the base to enter the retransmit-continuously mode, we set that
> satellite to 2Mbit (Standard) and we usually eliminate these problems.
>
> Karlnet has not yet given me any hopeful information, we are still at the
> inquisitive stage.
>
> Chris
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|