I believe the point they are trying to make is that two wireless devices can
communicate at full speed without the BCU interacting.
-bob
----- Original Message -----
From: "LaRoy McCann" <lmccann@roachconveyors.com>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Wednesday, July 16, 2003 12:03 PM
Subject: RE: [Karlnet] bandwidth management
> The information on the BCU states that it controls both the up and down
> speeds.
>
> If this is the case, then does it matter that the wireless devices talk to
> each other at full speed if the BCU controls the speed of everything
> between the base unit and the world.
>
> Would this not control the effective bandwith?
>
> full speed throttle point
> cpe <------------> base <----------> bcu <----------> world
>
> Just trying to understand this thing.
>
> LaRoy.
>
>
> At 11:25 AM 7/16/2003 -0500, you wrote:
>
> > >But the BCU is a Layer 2 bridge. It could not stop two wireless
devices on
> > >the same network from unlimited use. All it can throttle is outbound
> > >bandwidth. Correct?
> >
> >bingo
> >
> >-Charles
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
> >---
> >Incoming mail is certified Virus Free.
> >Checked by AVG anti-virus system (http://www.grisoft.com).
> >Version: 6.0.501 / Virus Database: 299 - Release Date: 7/14/2003
>
> LaRoy McCann
> Electrical Engineering Manager
> Roach Conveyors
> (870) 483-7631 x638
> www.roachconveyors.com
>
----------------------------------------------------------------------------
----
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.501 / Virus Database: 299 - Release Date: 7/14/2003
>
----------------------------------------------------------------------------
----
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|