Karlnet
[Top] [All Lists]

Re: [Karlnet] Transfer Rates

To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Subject: Re: [Karlnet] Transfer Rates
From: jna <jna@tcpbbs.net>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Thu, 27 Nov 2003 22:15:38 -0500
List-post: <mailto:karlnet@WISPNotes.com>
> John,
>
> Something is wrong in your setup, I would start doing tests between each
> segment using the PING FILL Test inside the configurator --
>
> Verify you are able to pull full speed through segment, and then test 2
> segments, then 3 until you have the entire link

Yes SOMETHING is wrong and that is what I am trying to figure out. But I did
start at the beginning. All towers (will be) connected to the central relay
point the KN-200. This gets its feed to the net from the PTP between the
central relay and the data center, the PTP consists of an RG SAT (@
datacenter) sending the feed to the 1st radio interface on the KN-200 Base,
the second radio interface is on a horizontal 8.5db omni. This is where I am
doing the testing, the configurator ping fill says the PTP link is pulling
around 3 1/2 MB/S but when I connect the the ethernet drop I only get
800-1.2MB/S to the net when we have 3MB/S being sent out.

> Also RG1000's max out around 1.6Mbps (up & down)

Thats what karlnet said. But why is the configurator measuring the
connection from the RG to the KN at 3MB/S+? Replacing the RG with another KN
would increase this by what?

Thanks,
John

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

<Prev in Thread] Current Thread [Next in Thread>