TenTec
[Top] [All Lists]

Re: [TenTec] 450 Ohm feedline

To: tentec@contesting.com
Subject: Re: [TenTec] 450 Ohm feedline
From: Ken Brown <ken.d.brown@verizon.net>
Reply-to: tentec@contesting.com
Date: Mon, 19 Apr 2004 20:45:06 -1000
List-post: <mailto:tentec@contesting.com>

Lest there be some confusion, although power companies twist primary lines,
they are putting BPL on Secondary lines that are not twisted, and therefore
radiate like blazes.


Even if the power companies were intentionally putting BPL on the HV primary lines, the twist on those lines would not be sufficient to maintain balance at HF frequencies. The twist on HV power transmission lines takes several miles to go through the whole twist sequence. This is a small fraction of a wavelength at 60 Hz, and so it can help to balance the capacitance with respect to ground on the three hot wires, at 60 Hz. At HF the twist could actually make the situation worse, making the transmission line act as a giant colinear array with fantastic gain in some directions at some frequencies.

DE N6KB






_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>