Hi Jamie -
I have an OMNI 6+ that came with a logic chip Model 564 Version 1.03
installed.
I had called Ten-Tec and mentioned that I am a CW op, not a SSB op. I said I
was trying to make sure no clicks, thumps, etc would be transmitted.
Because of my call, and to cure the problem, Ten-Tec sent me a Vers 1.02
chip.
It completely cleared any "unwanteds". Of course the Vers 1.03 was returned
to
T-T as a "trade". You might check to see what you have.
This might or might not be the answer to your mini-chirp and click problem,
but
it worked for me. On air reports are excellent.
My OMNI 6+ is a late '99 unit with surface mounted components, etc. Great
improvement over the earlier produced transceivers.
73 - Don, VE1BN
----- Original Message -----
From: "PatandJamie" <patandjamie@compuserve.com>
To: "anyone" <TenTec@contesting.com>
Sent: Sunday, March 26, 2006 11:13 AM
Subject: [TenTec] chirp in Omni 6 plus
> Can anyone help with chirp and key click problems in Omni 6? I have
> returned rig twice to TenTec for service and they can find nothing wrong.
> I
> have tried 3 different power supplies. Sometimes, I get a good tone report
> but most of the time I get reports of chirp and clicks. I have attached
> dummy load and listened in another receiver and can hear the chirp. Any
> suggestions?
>
> Jamie
> k5uu
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|