Gang....
I am still a bit confused (easy to do ) but now that I have the omni
VII talking to just one computer over a cross over ethernet
cable..things look like they could get dicey.
My next step will be trying to get the omni VII to talk to the network.
so... either I have to get a wireless game port thingiee (about $100)
or run a CAT five line between the router and the radio. However.. if
I am going to do that, I may as well connect the computer down in the
shack up as well. Right now it is running on a wireless link.
so will a HUB be needed to connect the omni and the computer together?
here's my setup
a linksys wireless access point router
cable modem
I can "look at" the router and see it's the standard 192.168.1.1 IP
address
using the whatsmyip.org I find my outside IP address as 24.140.XX.XX
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
Note: No trees were killed in the sending of this message, but a
large number of electrons were terribly inconvenienced
On Apr 27, 2008, at 2:03 AM, John Sheeley wrote:
----- Original Message ----
From: Gary Hoffman <ghoffman@spacetech.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Saturday, April 26, 2008 10:50:03 PM
Subject: Re: [TenTec] Hooking up Omni VII to computer ---direct--- how?
Modern wireless routers handle 45 Mbits/sec. I can't imagine using
that up
in this manner.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|