Gil,
I had that problem and it turned out to be a faulty front-panel switch.
You can check by temporarily lifting connector #92 from the IF/AF Board
- that should bring the AGC on in the FAST mode. If it is that, TT still
stock the switch.
73,
Steve G3TXQ
g p wrote:
Just got a used Corsair and the AGC does not come on when the switch is either
on slow or fast, it acts as if it were off on all three positions. I have
checked the boards for any indications of a bad connection etc, cleaned the
switch and still the same. I have had a couple of these rigs before and never
seen this problem.
Would appreciate any comments
Thanks, Gil
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|