| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair AGC problem |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 17 Jan 2010 12:04:12 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Thanks for the clarification - that fits my understanding on how to do that sort of thing. =============== K8JHR ========================= On 1/17/2010 9:10 AM, CSM(r) Gary Huber - AB9M wrote: > Power off - > Disconnect one connector at a time, put a bit of deOxit on a Q-tip and wipe > the pins up and down both sides and reconnect. Do not spray the connectors > or pins. Do all the connections, then power back up. > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Restoring backlighting for the Delta II or Its Argo, brother???, Bob Towers |
|---|---|
| Next by Date: | [TenTec] RigTalk, Jim Goudie |
| Previous by Thread: | Re: [TenTec] Corsair AGC problem, CSM\(r\) Gary Huber - AB9M |
| Next by Thread: | Re: [TenTec] Corsair AGC problem, Steve Berg |
| Indexes: | [Date] [Thread] [Top] [All Lists] |