| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair AGC problem |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 16 Jan 2010 23:57:57 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
You mean to apply the de-oxit to only the pins and connectors, right ? One would not want to get the stuff inside the display components...right? ================ K8JHR ============================= On 1/16/2010 10:38 PM, CSM(r) Gary Huber - AB9M wrote: > The frequency display is most likely another deOxit session for pins of > connectors of the display board, display driver, counter, time base, etc. ================================================== _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Corsair AGC problem, CSM\(r\) Gary Huber - AB9M |
|---|---|
| Next by Date: | Re: [TenTec] Corsair AGC problem, Steve Berg |
| Previous by Thread: | Re: [TenTec] Corsair AGC problem, CSM\(r\) Gary Huber - AB9M |
| Next by Thread: | Re: [TenTec] Corsair AGC problem, CSM\(r\) Gary Huber - AB9M |
| Indexes: | [Date] [Thread] [Top] [All Lists] |