Steve,
I believe it's 250K, but I'll have to dig deeper on it. All the
"old-school" Ten-Tecs use the same circuit with the RCA RC4136 quad op
amp (which was low-noise and the best you could do back then). I'll
look inot one of my Corsair II and let you know for sure.
--
Neal, NL7VL
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
On Sun, 06 Feb 2011 09:37:17 +0000
Steve Hunt <steve@karinya.net> wrote:
>I need to replace a fault "Notch" potentiometer on my CorsairII. It's
>dual-gang, and mounts to the IF/AF PCB as well as to the front panel.
>I can't see anywhere on the schematic that tells me its Ohmic value,
>or whether it is Log or Linear.
>
>I wonder if anyone happens to know the details. I'd prefer to obtain a
>replacement before pulling the radio apart, otherwise I could just
>measure the "good side".
>
>Thanks,
>Steve G3TXQ
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|