Steve,
The "Corsair" manual says 500K and all the component values are the
same in the Corsair II. I put a meter on on of the pots in the Corsair
II and got about 220K across both, but I think I'd go with the manual
and say you need a dual 500K (linear?) potentiometer.
What happened to yours? Did you physically bump it? You sure it's the
pot?
--
Neal, NL7VL
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
On Sun, 06 Feb 2011 09:37:17 +0000
Steve Hunt <steve@karinya.net> wrote:
>I need to replace a fault "Notch" potentiometer on my CorsairII. It's
>dual-gang, and mounts to the IF/AF PCB as well as to the front panel.
>I can't see anywhere on the schematic that tells me its Ohmic value,
>or whether it is Log or Linear.
>
>I wonder if anyone happens to know the details. I'd prefer to obtain a
>replacement before pulling the radio apart, otherwise I could just
>measure the "good side".
>
>Thanks,
>Steve G3TXQ
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|