TenTec
[Top] [All Lists]

Re: [TenTec] Radial Research

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Radial Research
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 19 May 2012 14:05:34 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

On 5/19/2012 8:50 AM, Bob McGraw - K4TAX wrote:

> Most studies concur that "buried radials" should not be deep but preferably
> at the surface.



                Hear, Hear !!!

                Surely the goal is the grab the RF before it can
                be absorbed by the lossy earth.

                My wife is the HUGE proponent of how they
                will be absorbed and lost in the thatch of the
                grass in about three week (tops) -  UNLESS your
                lawn service guy picks them up every week and
                replaces them when he is through mowing because
                he aims to please !


                [ Oops... probably should not have said my
                        my wife is ... a HUGE... anything !
                        She might not like take it in context...  ]

                ;-)


Also most instillations incorporate a conductive mat at and
> around the base of a vertical radiator where the ground current is highest.


                Most ?   Only the good ones !   I think most guys
                crap out early and rationalize they only need
                6 or 8 or 16 radials, because they think it is too
                much work to lay more.

                My only regret in building my big stick is that I
                was just starting out in ham radio when I installed
                it, and I wish I had taken more scientific readings
                with antenna analyzers, or let the local Elmers
                work it over with their equipment, to provide
                more detailed evidence of how it plays with a few
                radials, to compare with how it plays with more
                radials -  most of my assessment is my subjective
                take and it would be more useful with some hard
                data.



> This supports the discussions of using more and shorter radials will be
> better than fewer but longer radials.  i.e. - 20 radials of 20 ft each will
> be better than 4 radials of 100 ft each.  In both cases, 400 ft of wire
> required.


                Hear, Hear !



-------------------------  K8JHR  -----------------------------


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>