| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni VI+ option #3 off Freq |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 4 Jul 2012 23:17:33 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On Wed, Jul 4, 2012 at 11:02 PM, Robert Mcgraw <rmcgraw@blomand.net> wrote: > It does require a good / accurate frequency counter to set the BFO's > correctly. > > I use my accurately aligned K3 as my counter. Signal levels are perfect to feed the bfo oscillator test point directly into the RX ANT port of the K3. Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] My First Ten-Tec, Jim Lowman |
|---|---|
| Next by Date: | Re: [TenTec] new to CW dxing, Jim Lowman |
| Previous by Thread: | Re: [TenTec] Omni VI+ option #3 off Freq, Robert Mcgraw |
| Next by Thread: | Re: [TenTec] My First Ten-Tec - Marketing, george fritkin |
| Indexes: | [Date] [Thread] [Top] [All Lists] |