TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] Scads of used Icom IC-7300

from [shristov] [Permanent Link][Original]
To: tentec@contesting.com
Subject: Re: [TenTec] Scads of used Icom IC-7300
From: shristov <shristov@ptt.rs>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 11 Sep 2016 02:04:00 +0200
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
> > The clip point on my Flex 6500 is S9+80 DB.  That's +7 dbm. 
 
> 5W at the antenna input. That's a LOT of signal.

5 mW, not 5 W.


73,

Sinisa  YT1NT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] Paragon is it dead?, Louis Ciotti
Next by Date:  Re: [TenTec] Paragon is it dead?, Al Gulseth
Previous by Thread:  Re: [TenTec] Scads of used Icom IC-7300, Carl Moreschi
Next by Thread:  Re: [TenTec] Scads of used Icom IC-7300, rick@dj0ip.de
Indexes:  [Date] [Thread] [Top] [All Lists]