Snowy:
7335 (The old CHU time signal frequency, before it moved to 7850) is the
Paragon default frequency if the memories are erased, as in the case of
a dead battery or if the red reset button is pushed.
73,
Bob WB2VUF
On 9/20/2018 6:08 AM, ROLAND HOWELL via TenTec wrote:
Hi again gentsWell I found an old Elecraft kit which I hadn't made up so I used the
screws from that to replace the missing ones.refitted all the wires that I could find a
home for, then switched on, I was rewarded with audio and a display saying that PLL was
out of lock and figures 73350 in the frequency display area, so now I have to look
at which PLL is out of lock, measure the voltage I suppose in relation to the locked
PLL,s, unless you gents advise otherwise.So some success with it, maybe there is hope
after all.regardsSnowy G0HZE .
| | Virus-free. www.avast.com |
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|