theyre to keep Ice from sliding down the guy wires and wiping out the
pre-form, we buy all our preforms and such from pre-form line products
----- Original Message -----
From: "Pete Smith" <n4zr@contesting.com>
To: <towertalk@contesting.com>
Cc: <ackster@pcsonline.com>
Sent: Wednesday, April 10, 2002 9:51 PM
Subject: Re: [Towertalk] Guy Grip Question
>
> >Stan wrote:
>
> >I specfically remember reading in the Official Rohn Book that
> >when you use guy grips, you MUST always use end sleeves (NOT tie wraps)
with
> >them. They don't say why but if you can install a guy grip with your
hands
> >and nothing more than a screw driver, then it stands to reason that you
(or
> >any kid or vandal) can remove one the same way. If any guy grips are
> >accessable from the ground, I would strongly recommend installing end
> >sleeves to discourage, or at least slow down, a vandal or an irrate
> >neighbor. See page HA101 in your Rohn Book for installation procedure.
>
> Rohn isn't necessarily the last word on guy grips, of course, not like
> PLP. However, I was told (with straight face, I think), that water
sliding
> down guy wires and freezing inside the ends of guy grips could cause them
> to unravel gradually. I drove what are locally called "ice sleeves" on
all
> my upward-facing grips with a hammer and vise grips, and there they've
> stayed. I didn't think about the vandalism case then, but am doubly glad
I
> did it now.
>
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
|