Towertalk
[Top] [All Lists]

Re: [TowerTalk] Grounding, Lightning & corona discharge

To: Peter Sundberg <sm2cew@telia.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Grounding, Lightning & corona discharge
From: Jim Lux <jimlux@earthlink.net>
Date: Thu, 29 Jul 2004 09:56:18 -0700
List-post: <mailto:towertalk@contesting.com>
At 07:46 AM 7/29/2004 +0000, you wrote:
Just curious, how is the telco connection done in the states ? What is
there to connect to a single point ground?

Here in SM it is just two wires coming to the house from the telephone
pole, no screened cable to ground and no ground connection allowed on any
of the incoming wires.

73/Peter SM2CEW
www.qsl.net/sm2cew
At the "point of demarcation" there's usually some form of lightning arrestor/transient suppressor with a wire to the ground. The wire comes from the pole (or conduit, for underground service) to the demarc/arrestor, then the house wiring plugs into the demarc. IT serves a dual purpose of delineating whose wire it is (on the utility side or the homeowner side) and providing lightning protection. Bear in mind that the utility doesn't care about protecting YOUR equipment though. They're protecting their side (the drop, the cables, etc.)

Their goal and requirements for the device might be different from the consumers... hence the popularity of aftermarket protective devices... the phone company doesn't have a very complex system on their side of the line (wires, cables, splices, not much electronics until you get to the Central Office, and I'll bet the transient suppression on that end is a LOT better than at my end)

_______________________________________________

See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>