Re: [TowerTalk] 40M Homebrew Vertical - mounting ideas solicited

["Larry Banks" <larryb.w1dyj@verizon.net>]

Thanks Dan -- just the kind if simple idea I am looking for.  You even have 
the "raising fixture" shown that is close to what I envision!
73 -- Larry -- W1DYJ




----- Original Message ----- 
From: "Dan Schaaf" <dan-schaaf@att.net>
To: "Larry Banks" <larryb.w1dyj@verizon.net>
Sent: Wednesday, January 22, 2014 1:05 PM
Subject: Re: [TowerTalk] 40M Homebrew Vertical - mounting ideas solicited


> Larry
>
> I hope that I understand your question/dilemma. If so. take a look at the
> drawing I just made.
> I can imagine buying 3 pieces of pressure treated 2 x 4 . Then use 2 of 
> them
> as your "mast support" and the third one as your mast. Put a hinge pin at
> the top of the 2 mast supports and put the mast in between. Now you have 
> all
> 3 2x4s parallel except the middle one would extend above the supports by
> enough to attach the vertical antenna onto. Then connect a rope at the
> bottom of the middle 2x4 so that you can raise and lower the antenna .
> You just need to find a way to support the 2 outer pieces of wood. Maybe
> against the side of a house.
>
> If you arrange the elevate radials correctly, this will tilt down between
> them.
>
> Best Regards
> Dan Schaaf
> =================================
> K3ZXL www.k3zxl.com
> =================================
>
> -----Original Message----- 
> From: Larry Banks
> Sent: Wednesday, January 22, 2014 12:17 PM
> To: Tower Talk
> Subject: [TowerTalk] 40M Homebrew Vertical - mounting ideas solicited
>
> Hi all,
>
> I am building a homebrew 40M vertical with raised radials.  (Yes, I have
> studied the N6LF and K3LC literature.)
>
> It will be sitting on a 10 foot metal mast.  I am looking for ideas for
> mounting the driven element.  I want to be able to tilt the vertical over
> without effecting the radials.  Obviously, the radials and driven element
> must not be electrically connected to the mast or each other.  The 
> mounting
> method should not effect the radiation pattern -- implying that it cannot 
> be
> fabricated out of metal.  I also want to be able to raise the vertical
> myself without my XYL needing to help me.  I plan on fabricating this
> myself, only purchasing raw materials.
>
> I am open to any weird ideas!  Pictures are especially helpful.
>
> 73 -- Larry -- W1DYJ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk