VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] ARRL Proposal for a combined 10 Meter & 6Meter Conte

To: "'Dan Evans'" <dan.evans@insightbb.com>, "'Zack Widup'" <w9sz.zack@gmail.com>, "'VHF Contesting Reflector'" <vhfcontesting@contesting.com>
Subject: Re: [VHFcontesting] ARRL Proposal for a combined 10 Meter & 6Meter Contest
From: "Ron Rogers" <ww8rr@charter.net>
Date: Thu, 4 Sep 2014 19:12:14 -0400
List-post: <vhfcontesting@contesting.com">mailto:vhfcontesting@contesting.com>
I just knew there had to be a good reason why Cushcraft started making the
10 Meter Squalo antenna again !!!

ASQ-10 >>  50" X 50"  

Ron
WW8RR
-----Original Message-----
From: VHFcontesting [mailto:vhfcontesting-bounces@contesting.com] On Behalf
Of Dan Evans
Sent: Thursday, September 04, 2014 7:04 PM
To: 'Zack Widup'; 'VHF Contesting Reflector'
Subject: Re: [VHFcontesting] ARRL Proposal for a combined 10 Meter & 6Meter
Contest

I agree with most everyone else, a 10 & 6 meter contest would be fun!

Given a few points such as:

1.      A new contest, don't take away from any of the existing contests VHF
or HF...
2.      Use VHF contest general rules.  QSO's X Grids, etc...
3.      I agree that E'skip season would be ideal, but, it may be a bit
tough to schedule.  Between spring sprints, June VHF, Field Day, CQ-VHF,
IARU HF,        it's a busy season.  I'm not sure where to squeeze it in.

Zack is right, it will be another challenge for Rovers.  Before I got into
VHF contest Roving, I used to do several of the HF contests as a portable,
10 meter only.  The 102" whip will work well, particularly from a good
hilltop.  One of my best contests was done from a local hilltop using a
homebrew "bigfoot" mast support, 12' of mast, and an Antron 99 tuned for 10
meters.  The rig was an HTX-100 with about 25 watts out :-)  Of course, this
was back in the early 90's when 10 was pretty hot.

Today, I would likely use my VHF Rover setup with the pickup truck and push
up mast.  With the Moxon for 6 meters, and a 102" whip at the top of the
mast.

73
Dan
-- 
K9ZF 
Amateur Radio Emergency Service, Clark County Indiana. EM78el 
The once and future K9ZF /R no budget Rover 
 ***QRP-l #1269 
Check out the Rover Resource Page at: 
<http://www.qsl.net/n9rla> 
List Administrator for: InHam+grid-loc+ham-books 
Ask me how to join the Indiana Ham Mailing list!

-----Original Message-----
From: VHFcontesting [mailto:vhfcontesting-bounces@contesting.com] On Behalf
Of Zack Widup
Sent: Thursday, September 04, 2014 1:16 PM
To: VHF Contesting Reflector
Subject: Re: [VHFcontesting] ARRL Proposal for a combined 10 Meter & 6 Meter
Contest

I imagine the scoring would be like the other VHF contests - the exchange
would be grid squares and the mults would be grid squares, unlike the 10
Meter Contest where the mults are states/provinces/DX entities.

The problem I have with my own participation is that I usually do portable
operations from hilltops, and a 10 meter antenna might be more difficult to
manage unless I go with a 102 inch whip on the car for 10m.

73, Zack W9SZ


On Thu, Sep 4, 2014 at 11:41 AM, Vhfrover via VHFcontesting <
vhfcontesting@contesting.com> wrote:

>
>  I would be in favor of a combined 6 and 10M contest as long as it would
> NOT diminish the existing annual December ARRL 10M contest in any way.
The
> existing 10M contest is very popular and I have enjoyed participating in
it
> with my portable setup from one of the local rover hilltops.  A
combination
> 6 and 10M contest might even pull some of the HF contest operators to use
> the 6M position on their rigs.
>
> 73, Mike WB8BZK
>
>clip


---
This email is free from viruses and malware because avast! Antivirus
protection is active.
http://www.avast.com

_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

<Prev in Thread] Current Thread [Next in Thread>