Try pinging the AP rather than going all the way to the 'net first, if you
haven't already. Can you link test with the AP?
Norm
----- Original Message -----
From: <wireless@peake.com>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Friday, July 11, 2003 12:44 PM
Subject: [Karlnet] Wacko Karlnet
> What a day ;) Now my reliable notebook with Orinoco PC card is acting
> up. This laptop has been off for a few weeks. I turn it on this morning
> and I'm unable to connect to the Net. The TurboCell signal strength in
the
> systray shows good. I have a public IP address assigned to this
> LT. Nothing has been added/removed from the Laptop and the Wireless
> Network in the Control Panel (w98se) shows all the right setting like
> Frequency, Network etc.
>
> I used to be able to run the Karnet ConfigeV Bridge Configuration program
> and actually looks at my AP and other CPEs that I have (AP and CPE are all
> public IP, really small network).
> Now when I open remote config and press the scan button I get the "Unable
> to locate any device" error.
>
> I've rebooted the AP and the two other CPEs that are outside the building
> are working just fine.
>
> But my Spare CPE is also not working before and after I flashed it from a
> SR-4100 to a SR-4200. Using a crossover cable and NIC I can access the
> CPE, use the configV program to flash etc but I'm unable to get the CPE to
> talk to the AP.
>
> Open to suggestions.
>
> Thanks
> Chris
> wireless@peake.com
>
> ---
> [This E-mail scanned for viruses by Declude/F-Prot AV]
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
|