And with a Rigblaster Plus you can run FSK and CW from the same port.....73
----- Original Message -----
From: "Barry " <w2up@mindspring.com>
To: "Bill Turner" <w7ti@dslextreme.com>; <writelog@contesting.com>
Sent: Tuesday, May 28, 2002 7:37 PM
Subject: Re: AW: [WriteLog] Erratic CW
>
>
> On 28 May 2002 Bill Turner wrote:
>
> > On Tue, 28 May 2002 15:01:26 -0400, Roger Borowski wrote:
> >
> > >I can't imagine why so many go for the LPT port when
> > >you can use the same port as rig control for CW keying???
> >
> > _________________________________________________________
> >
> > Correct me if I'm wrong, but I think the reason folks want to use the
> > LPT port for CW is that there is a conflict if you want to use RTTY FSK
> > and CW on the same com port. I don't think it can be done, at least not
> > with MMTTY. This may not be true for all combinations of
> > mode/tnc/port/FSK/AFSK, but it was in my case.
> >
> <snip>
> OK, you're wrong :.)
> My COM ports are set up as follows:
> COM1 - modem
> COM2 - Radio
> COM3 - Packet
> COM4 - PTT/CW/FSK
> COM5 - Acom amp
>
> Obviously, I don't use CW and FSK at the same time, so when running
> WL/MMTTY, I choose None for CW in the Setup Ports window. When
> running CW, I choose COM4 and MMTTY isn't open.
> Barry --
> Barry Kutner, W2UP Internet: w2up@mindspring.com
> Newtown, PA Frankford Radio Club
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
|