In a message dated 7/16/2006 8:13:55 A.M. Eastern Standard Time, r@somis.org
writes:
> The SB-220 was rated at 2KW PEP input which is 1 KW DC input.
I don't see how.
You don't see how....What? Am I mistaken that the Sb-220 was rated at 2KW
PEP input? It does say it on the front panel, though it does not say
"input" it does say 2KW amplifier. Or...Do you mean to say that 2KW is not
the
same as 1KW DC input? There has been a lot of discussion over the years,
especially in the early days when one did not have a PEP reading watt meter.
So,
the rule of thumb "at the time" was that PEP was ~ twice the average DC input.
SO...What don't you see?
If you will recall the poster's original question you did not give him an
answer. If you have a better explanation to his question, PLEASE do so. Lou
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|